|
Substrates |
Dried and sanded existing finishes, all kinds of primer and putty. |
||
|
SurfaceCleaning |
Wash by warm soap, remove wax, silicon and other contaminations with degreaser,sanding with P800-P1000, wash with clean water then keep dry; again with degreaser. |
||
|
MixingRatio |
BYTF606-2K Primer Surfacer |
BYTH106 2K Primer Hardener |
Thinner |
| 4 | 1 |
1-1.5 |
|
|
＜15℃ |
BYTF606 2K Primer Surfacer |
BYTH106 2K Primer Hardener |
BYTX-1 FastThinner |
|
15-30℃ |
BYTF606 2K Primer Surfacer |
BYTH106 2K Primer Hardener |
BYTX-2 StandardThinner |
|
＞30℃ |
BYTF606 2K Primer Surfacer |
BYTH106 2K Primer Hardener |
BYTX-3 SlowThinner |
|
Pot-Life |
At 20°C, 3 hours mixed with hardener, thinner |
||
|
SprayViscosity |
14-16s to drop off, in 4# viscosity cup at 25°C, |
||
|
Spray GunSet Up |
Gravity Feed: 1.2-1.5mm 4-5kg/cm 2 Suction Feed: 1.4-1.6mm 4-5kg/cm 2 |
||
|
SprayTechnology |
Coats&Thickness: 2-3 coats, total 20-30um. Flash-Off Time: At 25°C, 5-10 minutes between two coats,it depends on temperature and paint film. |
||
|
Drying Time |
A. Allow 10-20 minutes air-drying,then 60°C baking 20 minutes, can sand after cool down. B. Air-drying time 3 hours, at 20°C. |
||
|
Shelf Life |
2 years in original sealed can, cool and dry place at 25℃. |
||
|
Package |
1L×12 or 3.75L×4 |
||
Note:
1. The substrate must be cleaned and sanded before spray, wet sanding P800-1000 and then dry.
2. At ambient temperature higher than 30℃, add appropriate Retarder Solvent into thinner to avoid blushing. For more details, please refer to technical data sheet of Retarder Solvent.
3. The products mixed with hardener should be used up soon and can not be restore for future use;clean equipments immediately with thinner after application, otherwise it is very difficult to be cleaned after dry.
