|
Substrates |
Dried and sanded existing finishes, steel, aluminium, stainless steel, galvanized steel, glass fiber reinforced plastic. |
||
|
Surface Cleaning |
Wash by warm soap, remove wax, silicon and other contaminations with degreaser, sanding with P800-P1000, wash with clean water then keep dry; again with degreaser. |
||
|
Mixing Ratio |
MF605 Epoxy Primer |
MF105 Epoxy Hardener |
MF63 Epoxy Thinner |
| 4 | 1 | 1~2 | |
| ＜30℃ |
MF605 Epoxy Primer |
MF105 Epoxy Hardener |
MF63 Epoxy Thinner |
|
Spray Viscosity |
16-19s to drop off, in 4# viscosity cup at 25°C, |
||
|
Pot-life |
Sanded with P600 or P800 sand paper, do following construction after drying |
||
|
Spray Gun/Set Up |
Gravity Feed: 1.2-1.5mm 4-5kg/cm ² Suction Feed: 1.4-1.6mm 4-5kg/cm ² |
||
|
Spray Technology |
Coats&Thickness: 2-3 coats, total 25-35um.Flash-Off Time: At 25°C, 5-10 minutes between two coats, it depends on temperature and paint film. |
||
|
Drying Time |
A. Allow 10-20 minutes air-drying,then 60°C baking 30 minutes, can sand after cool down. B. Air-drying time 3 hours, at 20°C. |
||
|
Shelf Life |
2 years in original sealed can, cool and dry place at 25℃. |
||
|
Package |
1L×12 or 3.75L×4 |
||
